Attwood Boat Cover Repair Kit User Manual download pdf

Boat Cover

Reinforcement/Repair Kit

10556, 10559

Attwood offers a complete selection of boat accessories, trailer

accessories, boat covers and tops under the Attwood and Road

Ready

brand names.

Attwood marine accessories are specified more than any other brand

by America’s best-known boat manufacturers as original equipment.

Look to Attwood for quality replacement parts and marine

accessories.

SAVE THESE INSTRUCTIONS

Form Number 69290 Rev. B 03-11

WARNING!

Add-on accessories such as fish finders, down riggers, rod holders,

anchoring devices, etc. can severely damage your cover and void your

warranty.

Immediately reinforce your cover with the enclosed easy to apply

reinforcement/repair kit in areas where accessories noticeably protrude

when your cover is first installed. Additional reinforcement/repair kits are

available from your dealer.

Reinforcement/Repair Instructions:

1. Open reinforcement/repair kit and spread material over any flat

surface.

If you are repairing your cover, skip to #7, otherwise continue from here.

2. Place boat cover on boat and secure it as if you were going to put the

cover in use. (Note: if you are using cover support poles, straps, or

bows make sure these are in position prior to marking your cover for

reinforcement.

3. Using a piece of chalk, mark the outside of your cover where you want

to place reinforcements. Special attention should be paid to high

stress areas such as windshield corners.

4. Using material from the kit, cut out a piece of material to match each

area you have marked on the outside of the cover.

5. Once all areas have been marked, and pieces have been cut, carefully

remove the cover from the boat and lay the marked side of the cover

toward the floor.

6. Carefully align reinforcement pieces on the opposite side of the cover

from where you made your marks.

7. Cover outer edges of the cut out reinforcement/repair piece with the

provided glue, and carefully apply to the cover.

8. Allow glue to dry for at least four hours before moving. The adhesive

will make a waterproof seal on most surfaces after 72 hours of drying.

9. Additional reinforcement and padding may be needed around trolling

motor propellers.

1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com

Boat Cover 1
Reinforcement/Repair Kit 1

Summary of Contents

Page 1 - Reinforcement/Repair Kit

Boat CoverReinforcement/Repair Kit10556, 10559Attwood offers a complete selection of boat accessories, traileraccessories, boat covers and tops under

Comments to this Manuals

No comments

Attwood Boat Cover Repair Kit User Manual

Browse online or download User Manual for Hardware Attwood Boat Cover Repair Kit. Attwood Boat Cover Repair Kit User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Attwood Boat Cover Repair Kit